P-00

Additional lead time required for 20 gal and 220 gal units.

N/A

It is always preferred to mix the entire kit, whenever possible, to avoid off-ratio mixtures

Verify that substrate temperature is above 5 degrees of dewpoint during application and cure of material to avoid a potential amine blush

Warmer temperatures will reduce viscosity and lower temperatures will increase viscosity

Warmer temperatures will decrease gel time and lower temperatures will increase gel time

Warmer temperatures will reduce time and colder temperatures will increase time

Warmer temperatures will reduce time and colder temperatures will increase time

Warmer temperatures will reduce time and colder temperatures will increase time

Warmer temperatures will reduce time and colder temperatures will increase time

Warmer temperatures will reduce time and colder temperatures will increase time

Warmer temperatures will increase hardness

Warmer temperatures will shorten time to reach full hardness

Applying material close to dew point will decrease gloss and may result in an amine blush

EPA Method 24

Clear to slightly amber before colorants are introduced

Store material between 60-90 degrees F in a protected dry location.

Measuring odor offensiveness is difficult so experience with chemicals has been consulted here

Combine all of part A and B into a single container, large enough to accept the entire kit. Mix at 350 RPM for 2-3 minutes using an appropriate mixing blade and making sure not to introduce excessive air into the solution. Pour the entire content from the container onto the floor and follow normal squeegee and back roll techniques. To make an epoxy patching material mix no more material than can be mixed and applied within the stated Gel time and add the selected aggregate until the desired thickness is achieved. Recoat within 24 hours. Clean tools with a solvent similar to Xylene or Acetone.